These I did not fully remove, instead loosening their
screws and swiveling them to extend outwards from the table at a right
angle, tightening them again afterwards so that they were secure.
Once that was accomplished, I went to the frame that had held the carpet
down and took the pins and fasteners which were used to secure it. These
I placed on the crescent beams from the couch, which used the same
standard size. Once I had secured the carpet sections to the beams, I
attached the couch's beams, via the cords, to the long beams sticking
outward from the table, running the ends of all the cords through
another cord that could, upon being pulled, adjust their height by
pulling or releasing, thus controlling the distance between the upper
and the lower beams, and changing the amount of slack in the carpet that
was stretched between them. I then removed the legs from the tabletop,
leaving just it and the beams together, the carpet being attached to the
beams.
Thus my plan was completed, it being, in case you hadn't guessed, a
primitive hang glider, the carpet being a sail and the beams the wings,
the whole being steerable by either raising or lowering one side or the
other, and the altitude being adjustable by raising or lowering the two
simultaneously.
Pages:
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159